1. When installing the planetary gear reducer, attention should be paid to the alignment of the transmission center axis, and the error shall not be greater than the compensation amount of the coupling used.

2. When installing the transmission part on the output shaft, it is not allowed to hit it with a hammer. Usually, the assembly clamp and the internal thread of the shaft end are used to press the transmission part in with bolts.

3． The gear reducer should be firmly installed on a stable and horizontal foundation or base, the oil in the oil drain tank should be able to be drained, and the cooling air should circulate smoothly. The foundation is unreliable, causing vibration and noise during operation, and causing damage to bearings and gears.

4. The gear reducer uses oil pool splash lubrication. Before operation, the user needs to remove the screw plug of the vent hole and replace it with the vent plug. Press the different installation positions and open the oil level plug screw to check the height of the oil level line.

5. Install the device according to the regulations to ensure that workers can easily get close to the oil mark, breather plug, and oil drain plug.