VDX Planetary Reducer Series

Planetary Gear Reducers Planetary Gear Reducers

Planetary Reducer VDX60

Single-stage: ≤3 arcmin(P1)
Two-stage: ≤5 arcmin(P1)
The reducer ring gear, output shaft, planet carrier and input shaft are all made of 40Cr high-quality alloy structural steel. After hot forging, quenching and tempering and other processes, they have good comprehensive mechanical properties, low notch sensitivity and impact toughness, thus making them better than die-casting. , ordinary steel and other materials have higher strength and toughness.
The gear is made of 20CrMnTi high-quality alloy steel. After heat treatment, carburizing and quenching of the tooth surface, the hardness of the gear tooth surface can reach HRC59~62. Using KISSsoft's design analysis, the tooth shape and tooth direction of the gear are adjusted to increase the service life and accuracy of the gear and reduce the meshing noise of the gear.

GET A QUOTE

Reducer Model Description

Planetary Reducer Model Description VDX60

Dimensions of the Reducer

Dimensions of the Planetary Reducer VDX60
Adapted motor
Specification ΦD E LB LZ LA LE LD L
Single Dual
100W Servo Ø8 37 Ø30 4-M3/M4 Ø45/Ø46 Φ80 60*60 80 101
200W Servo Ø11 37 Ø50 4-M4 Ø70 Ø80 60*60 80 101
400W Servo Ø14 37 Ø50 4-M4/M5 Ø70 Ø80 60*60 80 101
750W Servo Ø19 42 Ø70 4-M5/M6 Ø90 Ø105 80*80 85 106
57 Stepper Ø6.35/Ø8 37 Ø38.1 4-M4 Ø66.6(47.14*47.14) Ø80 60*60 80 101
60 Stepper Ø8 37 Ø36 4-M4 Ø70.7(50*50) Ø80 60*60 80 101
86 Stepper Ø12.7/Ø14 42 Ø73 4-M5 Ø98.4(69.6*69.6) Ø115 85*85 85 106
Solid shaft output mode
S(Shaft with key) S1(Smooth output shaft) T(Custom shaft)
S shaft S1 shaft According to customers
1. Dimensions marked with * vary depending on the installed motor.
2. The input shaft diameter of model 60 is ≤19mm, and input with key is optional.
3. The output shaft diameter of model 60 is ≤25mm.

Reduction Ratio

planetary reducer reduction ration
 

Reducer Parameters

Planetary Reducer Parameters VDX60
planetary reducer application drawing
*1、Ratio i=Nin/Nout (Input speed/output speed)
*2、When the speed of the output shaft of the reducer is100r/min, it acts on the midpoint of the output shaft of the reducer, and the direction of action is perpendicular to the output shaft, meeting the maximum radial force that the output shaft can withstand when the life of the reducer is 20000H.
*3、High/low temperature grease can be customized according to the use environment.

Install


planetary reducer install vdx series

Enquiry

feedback
top