VDX Planetary Reducer Series

High-Precision Planetary Reducer High-Precision Planetary Reducer

Helical Planetary Reducer VDX90

Single-stage: ≤3 arcmin(P1)
Two-stage: ≤5 arcmin(P1)
The reducer ring gear, output shaft, planet carrier and input shaft are all made of 40Cr high-quality alloy structural steel. After hot forging, quenching and tempering and other processes, they have good comprehensive mechanical properties, low notch sensitivity and impact toughness, thus making them better than die-casting. , ordinary steel and other materials have higher strength and toughness.
The gear is made of 20CrMnTi high-quality alloy steel. After heat treatment, carburizing and quenching of the tooth surface, the hardness of the gear tooth surface can reach HRC59~62. Using KISSsoft's design analysis, the tooth shape and tooth direction of the gear are adjusted to increase the service life and accuracy of the gear and reduce the meshing noise of the gear.

GET A QUOTE

Reducer Model Description

Planetary Reducer Model Description VDX90

Dimensions of the Reducer

Dimensions of the Planetary Reducer VDX90
Adapted motor
Specification ΦD E LB LZ LA LE LD L
Single Dual
400W Servo Ø14 46 Ø50 4-M4/M5 Ø70 Φ120 90*90 100 130
750W Servo Ø16 46 Ø80 M6 Ø100 Ø120 90*90 100 130
Ø19 46 Ø70 4-M5/M6 Ø90 Ø108 80*80 100 130
1500W Servo Ø19 61 Ø95 M8 Ø115 Ø130 100*100 115 243.5
Ø22 61 Ø110 M8 Ø145 Ø165 120*120 115 145
86 Stepper Ø14/Ø15.875 46 Ø73 4-M5 Ø98.4(69.6*69.6) Ø115 86*86 100 130
Solid shaft output mode
S(Shaft with key) S1(Smooth output shaft) T(Custom shaft)
S shaft S1 shaft According to customers
1. Dimensions marked with * vary depending on the installed motor.
2. The input shaft diameter of model 90 is ≤24mm, and input with key is optional.
3. The output shaft diameter of model 90is ≤35mm.

Reduction Ratio

Series Single Dual
Ratio Recommended               25   35        
3 4 5 7 10 12 15 20 28   40 50 70  
Not recommended                 30         100
Nominal torque Nm 90 105 110 95 85 110 115 125 125 90 125 130 105 85
 

Reducer Parameters

Planetary Reducer Parameters VDX90
planetary reducer application drawing
*1、Ratio i=Nin/Nout (Input speed/output speed)
*2、When the speed of the output shaft of the reducer is100r/min, it acts on the midpoint of the output shaft of the reducer, and the direction of action is perpendicular to the output shaft, meeting the maximum radial force that the output shaft can withstand when the life of the reducer is 20000H.
*3、High/low temperature grease can be customized according to the use environment.

Install


planetary reducer install vdx series

Enquiry

feedback
top